What Skalnivo does with a PDF file
- Opens multi-page, vector and scanned PDFs; lets you choose a page, shows thumbnails and fits the view to the width or the whole page.
- Respects the page rotation stored in the file. In an internal test, 34 of 58 pages had a rotation of 270 degrees, and measurements after rotation were correct.
- Asks for a password when a document is protected, and shows a message when a file is damaged.
- Saves calibration and measurements for each page separately. Changing page does not carry the scale over unless you decide so.
Why a PDF needs calibrating
A PDF page has a size given in points (1 point is 1/72 of an inch), not in real-world metres. The note “1:100” on the sheet describes the original printout. If the PDF was made from a sheet that was reduced (for example A3 to A4), the stated scale no longer applies, and the file holds no information about that change.
In an internal test on real drawings, in 3 of the 4 sheets checked the scale in the title block did not match the file's scale, because the sheet was reduced on export. That is why Skalnivo does not guess the scale and asks for a known dimension instead. Details: A printout that is not to scale.
Vector PDF and PDF from a scan
A vector PDF stores lines as coordinates, so it stays sharp when zoomed in and a point can be placed with a precision limited mainly by the finger. A PDF from a scan is an image: its accuracy depends on the scan resolution and the distortion of the paper, and at high zoom the lines blur.
How to measure a distance on a PDF
Measuring a distance on a PDF drawing in Skalnivo
Step 1: Open the file
On the Open screen, choose a PDF file from the device, or open it from email or a messaging app using “Open in Skalnivo”.
Step 2: Choose the page
If the file has several pages, choose the right one in the Pages menu. Calibration applies only to that page.
Step 3: Calibrate on a known dimension
Tap the central Tools button, choose Calibration (Whole page or Area), pick points A and B at the ends of a labelled dimension and enter its value with the unit. The app shows the message Calibrated and, when the page units are known, the Resulting scale 1:N.
Step 4: Measure a segment
From the Tools panel choose Distance and pick two points. The result appears on the drawing in the unit you chose.
Step 5: Check the result against a second dimension
Tap Check with a 2nd dimension and place another labelled segment. The app shows the deviation; above 1% the page status is Needs checking, which points to the printout scale, the calibration segment or another scale in that view.
Sheets with several scales
Detail sheets often hold several views at different scales (for example 1:10 and 1:15). Calibration in the Whole page mode applies to the whole page, and in an internal test measuring an element at a different scale gave deviations of tens of percent. So you calibrate each view separately in the Region (view at another scale) mode: tap two corners of the view, then a segment of known length. When a measurement enters an area with another calibration, or leaves the calibrated area, the app warns you and lets you choose the calibration. It does not recognise views by itself, so you mark the areas.
Limitations
- You have to pick and enter the known dimension yourself; dimension labels in a PDF are not read automatically.
- The result is no better than the drawing: a wrong dimension label means a wrong calibration.
- Snapping to PDF vectors works in the mobile app; in the browser it covers only measurement points, and a scanned PDF (an image) has no vectors to snap to.
- The scale 1:N is shown when the page units are known; it applies to a print at the PDF page size, and the scale in the title block may be outdated.
Frequently asked questions
Can I measure a PDF if I do not know the scale?
Does calibration apply to the whole PDF file?
Does the app change my PDF?
Why does the scale in the title block not match my measurement?
Related pages
Updated:
