How to measure distance and run length on a drawing

The Distance tool measures a segment between two points, and Polyline length adds up consecutive segments, for example the run of a pipe or cable. Both need the page to be calibrated first.

Distance between two points

Measuring distance and polyline length in Skalnivo

  1. Step 1: Calibrate the page

    If the status is Not calibrated, calibrate first by following the Your first calibration guide.

  2. Step 2: Choose a tool

    Tap Tools, then Distance (for a single segment) or Polyline length (for a run with several segments).

  3. Step 3: Place the points

    Tap the drawing briefly to place a point. Distance needs only two points; for Polyline length, keep placing points and finish with Done or by tapping the last point.

  4. Step 4: Adjust the points

    Hold a point and drag it. The Precision magnifier shows an enlarged view next to your finger, and the step buttons move the point by 1 dp. Undo and Redo on the top bar work on every step, and changes are saved automatically.

  5. Step 5: Read the result

    The result appears in a label on the drawing, in the unit and with the precision set in Profile.

  6. Step 6: Name and copy

    In the Measurements tool you can give a measurement a name (for example Corner to window), copy the value, hide it or delete it.

Tips

  • Zoom in before placing a point: zoom does not change the result, but it reduces the error in placing the point.
  • One finger pans the document and two fingers zoom; Zoom in and Zoom out are also in the document menu (⋮). A short tap places a point.
  • Snapping covers the points of existing measurements, PDF vectors (in the mobile app; in the browser only measurement points) and DWG/DXF geometry. You switch it on or off in Profile, and a Snapped message appears when a point snaps.
  • If a measurement crosses an area with a different calibration, the app warns you and lets you choose the calibration (Calibration used).
  • Measuring the run of a pipe from a drawing is covered in the guide Length of a service run.

Updated: